SHT20例程
# This is an library to use SHT20 Temperature sensor in Raspberry Pico Board. Written in Micropython.# Author : Ömer Tuğrul, 05.08.2022
# https://github.com/omer38/SHT20-TemperatureSensor
from time import sleep, sleep_ms
from machine import Pin, I2C
from struct import unpack as unp #interpret bytes as binary data
SHT20_addr = 64
# SHT Register addresses, convert them to byte array
trigger_T_measurment_nh = b'\xf3'
trigger_T_measurment_h = b'\xe3' #Hold Master mode: Block devices for other communications. SCL line is blocked.
write_ureg = b'\xe6'#b"11100110"
read_ureg = b'\xe7'#b"11100111"
s_reset =b'\xfe' #b"11111110"
class SHT20:
def __init__(self, scl_pin , sda_pin , clk_freq=300000): # max 400kHz
self._addr = SHT20_addr
pin_clk = Pin(scl_pin)
pin_data = Pin(sda_pin)
self._bus = I2C(0,scl=pin_clk, sda=pin_data, freq=clk_freq)
def get_temperature_C(self):
self._bus.writeto(self._addr, trigger_T_measurment_nh )
sleep_ms(150) # delay must be inserted, otherwise it gives error. Cannot read-write at the same time.
data = self._bus.readfrom(self._addr, 2)#sensor output 2 byte = 14 bit temperature data.Each byte is followed by an acknowledge bit. The two status bits, the last bits of LSB, must be set to ‘0’ before calculating physical values.
signal = unp('>h', data)# Packaging type: DFN packaging
self.__value_c = -46.85 + 175.72 * (signal / 65536)#temperature conversion in celcius in the datasheet.
return self.__value_c
def get_temperature_F(self):
val_conv = self.get_temperature_C()
self.__value_F = (val_conv*1.8) + 32
return self.__value_F
def get_temperature_K(self):
val_conv = self.get_temperature_C()
self.__value_K = val_conv + 273.15
return self.__value_K
页:
[1]